Loading Option Parameters

**WARNING: HOLDING DOWN 7 AND 9 KEYS WHILE POWERING ON THE CONTROL WILL CLEAR/DELETE ALL EXISTING MEMORY IN THE CONTROL**

1) Hold down keys 7 and 9 while powering on the control to dump memory/clear file. Control will then come up in IPL mode.

Hold down the . and – keys, while powering on the control, if you only want to get to IPL MODE without clearing control memory.

2) In IPL mode, Type in 99, then input.

3) At the first (?) type in the first password, then hit input. The passwords will not appear on the screen. Do the same for the second and third passwords. *This step only applies for the 15 control.*

4) Initialize/Generate system label ok? Choose `{`Y`}` for yes.* On the 15 control, this step will not be used.*

5) Axis ? # of axes Examples: Standard Lathe=2 (X and Z)
Standard Mill=3 (X, Y, & Z)

6) Start putting 9100 option parameters in. Parameters are in hexadecimal. Ex. Option 3? 22 then input key. Binary – 00100010 Hex – 22

7) If you are not putting any parameters in any of the options, skip them by hitting the input key.

8) If you miss an option or put the wrong information in an option you will have to start over from the beginning.

9) When done loading options, input down to clear file of ? Type in Y, then input.

10) Choose 6 end IPL to end IPL mode.

11) Ready to load parameters.