Archives: FAQs

* WARNING * Use extreme caution while working with or near any moving parts or electrical components. Fatal voltages may exist on the control components, DISCONNECT POWER before attempting any service. Machine Model: Problem: Diagnostic procedures and possible solutions 6TA/B Machine will not zero return: When the machine zero returns, does it decel?  If not, […]

[Note: A 414 alarm indicates you need to look at your servo drives or servo modules. If after looking at the drives or modules you find an HC LED lit or an 8, 9, A (or 12 for spindle) on the seven-segment display, then you have a high current alarm. Solving for a high current […]

Alarm A (AL-A) ROM Abnormality Cause: Incorrect ROM, ROM not installed correctly, error with control circuit. Remedy: Install correct ROM, replace control circuit. Alarm 01 (AL-01) Motor Overheat Causes: Damaged motor fan, overload, motor cooler is dirty, loose connection. Remedy: Replace parts, clean cooler, check connections, review cutting conditions. Alarm 02 (AL-02) Excessive Speed Deviation […]

Data Input/Output Operation Output the following data when it is possible in normal conditions. a. CNC parameter b. Pitch error compensation data c. PMC parameters d. Custom Macro Variables e. CAP data f. Part programs g. Tool offset data 1. Check the parameters for data output operation. *The data is not able to output in […]

Hold down the right two soft keys under the screen to get into the Boot System and turn on control. Install the card in slot on the front of the control. Select SYSTEM DATA LOADING from the main menu. Select DGSERVO (This will be the only file on the card). Select YES when prompted. Wait […]

Put control in mdi mode Press offset/setting hard key Press setting soft key Parameter write enable should be displayed at top of screen and should be highlighted Press “1” and input Should now see alarm screen with “p/s 100 parameter write enabled” Press system hard key Press parameter soft key Type in parameter “2165” then […]

**WARNING: HOLDING DOWN 7 AND 9 KEYS WHILE POWERING ON THE CONTROL WILL CLEAR/DELETE ALL EXISTING MEMORY IN THE CONTROL** 1) Hold down keys 7 and 9 while powering on the control to dump memory/clear file. Control will then come up in IPL mode. Hold down the . and – keys, while powering on the […]